Fits Roll Bars or Bull Bars of 1", 1.5", 1.75" or 2" diameter (25,40,47 or 50mm)

T-handles allow for fast on and off of jack

Roll Bar Mounts and the inserts are made of glass filled nylon and guaranteed against breakage for life.

Contents:

• 2 each 2” (50mm) Roll Bar Mounts
• 2 each 1 3/4” (47mm) snap-in inserts
• 2 each 1 1/2” (40mm) snap-in inserts
• 2 each 1” (25mm) snap-in inserts
• 2 each 5/16” bolts
• All the necessary stainless steel hardware

Two good ways to install QUICK FIST clamps are with Jacknuts® or rivetnuts.

Jacknut® Threaded inserts

Jacknuts are a fast and inexpensive way to put a nut into a place where there is no access for a traditional nut. After drilling a hole, the Jacknut is inserted and then tightened with the proper sized bolt. The “legs” of the Jacknut collapse to grip the inside of the mounting surface, leaving a permanent, reusable nut in the hole.

Rivetnuts (best known brand is Nutserts®)

These are nuts that can be riveted into drilled holes. Like Jacknuts these are particularly good to install where the underside of a mounting hole cannot be accessed. To install rivetnuts, you will need a special type of rivet gun or find a garage that will install them for you.